The error codes E nFLo and Er, nF on your Speed Queen washer both indicate a No Water Flow Error. This signifies the washer is unable to fill with water properly during the wash cycle. Here's an explanation of the problem, potential causes, troubleshooting steps you can try and when to consult a qualified technician
No Water Flow Error (E nFLo or Er, nF)
- Insufficient Water Supply: The most common cause could be a lack of water pressure coming into the washer. This could be due to a closed shut-off valve, a kinked or clogged hose, or low water pressure in your home's plumbing.
- Clogged Inlet Screens: Screens within the washer's inlet valves that filter incoming water might be clogged with debris, preventing sufficient water flow.
- Faulty Inlet Valve: In rare cases, the inlet valve itself, which controls water flow into the washer, might be malfunctioning.
Troubleshooting Steps
Important Note: While the following steps might resolve the issue, some involve accessing the washer's water supply. Proceed with caution and only if you are comfortable:
- Check the Water Supply: Ensure the shut-off valve connected to the washer's cold water supply hose is fully open. Check if other faucets in your house have good water pressure to rule out a house-wide water pressure issue.
- Inspect the Inlet Hoses: Locate the hot and cold water inlet hoses at the back of the washer. Check for any visible kinks or blockages in the hoses. You might also turn off the water supply and disconnect the hoses to inspect the screens inside the hose connections for debris. Clean the screens carefully if necessary.
- Consult the Manual: Refer to your Speed Queen washer's user manual for specific instructions on locating and cleaning the inlet screens. Some models might have them readily accessible within the washer, while others might require accessing the back panel.
If the Error Persists
- Contact Speed Queen Support: If the troubleshooting steps don't resolve the issue, contacting Speed Queen's customer support is recommended.They can provide further guidance and determine if the issue requires a qualified technician's expertise.
- Qualified Technician (Recommended): For a confirmed faulty inlet valve or if you're uncomfortable with the troubleshooting steps, consulting a qualified appliance repair technician is recommended. They can diagnose the problem accurately (low water pressure, clogged screens, faulty inlet valve) and recommend the appropriate solution (repair or replacement of the necessary components).
Safety Considerations
- Turn Off Water Supply: Before disconnecting any hoses, ensure the water supply to the washer is turned off at the shut-off valve to prevent leaks.
- Avoid Electrical Work: Leave any electrical troubleshooting or repairs to qualified technicians.
By following these steps and prioritizing safety, you can potentially address the cause of the E nFLo or Er, nF error on your Speed Queen washer. But for a proper diagnosis and repair of a faulty inlet valve or other internal components, consulting a qualified technician is the best course of action.