The error code E Sd or Er, Sd on your Speed Queen washer indicates a Slow Drain Error. This means the washer is taking longer than expected to drain the water from the tub during the draining process. While similar to a regular Drain Error (E dr), a Slow Drain Error signifies the water is eventually draining, just at a slower pace.
Here's a breakdown of what it means, potential causes, and troubleshooting steps you can try (with caution) before seeking professional help
Possible Causes of Slow Drain Error (E Sd or Er, Sd)
The washer is experiencing a slow draining process, potentially leaving some residual water in the tub before the spin cycle or the end of the wash program. Several factors could contribute to this:
- Partial Clog in Drain Hose or Filter: A minor clog in the drain hose or drain filter might be restricting the water flow, causing slower drainage.
- Debris in the Pump: Lint, coins, or other small objects might be partially obstructing the drain pump, hindering its efficiency.
- Defective Drain Pump (Less Likely): In rare cases, a failing drain pump could be the culprit, although a complete drain failure is more likely in this scenario.
- Kinked Drain Hose: If the drain hose is bent or kinked, it can restrict water flow and slow down the draining process.
Troubleshooting Steps
NOTE: Proceed with Caution
Important Note: While the following steps might resolve the issue, some involve potential electrical components or water. Proceed with caution and only if you are comfortable:
- Unplug the Washer: Before attempting any troubleshooting, ensure the washer is unplugged for safety reasons.
- Check the Drain Hose: Inspect the drain hose for any visible kinks or clogs. Straighten the hose if necessary.
- Clean the Drain Filter: Locate the drain filter, typically near the bottom front of the washer. Consult your washer's manual for specific instructions on cleaning it. Remove any accumulated debris you find.
- Check for Objects in the Pump (if accessible on your model): Some Speed Queen models might allow access to the drain pump area. If you can safely reach it (consult your manual), visually inspect for any objects that might be partially blocking the pump.
If the Problem Persists:
- Consult the Manual: Refer to your Speed Queen washer's user manual for additional troubleshooting steps specific to your model.
- Contact Speed Queen Support: If the above steps don't resolve the issue, contacting Speed Queen's customer support is recommended: They can provide further guidance and determine if the issue requires a qualified technician's expertise.
- Qualified Technician: In some cases, a qualified appliance repair technician might be needed. They can diagnose the problem (partial clog, debris in pump, faulty drain pump, kinked hose, or other issues) and recommend the appropriate solution, which could involve cleaning components, replacing the drain pump, or addressing a blockage in the drain hose.
Safety Considerations:
- Limited User Repair: If you're not comfortable with troubleshooting steps involving water or electrical components, it's best to avoid DIY repairs and consult a technician.
- Professional Help for Drain Pump Issues: Diagnosing and repairing a potentially failing drain pump typically involves technical knowledge and might require replacing the component. It's best to leave this to a qualified technician.
By following these steps and prioritizing safety, you should be able to resolve the E Sd or Er, Sd error on your Speed Queen washer. If the issue persists, don't hesitate to seek help from a qualified technician.