F17
The F20 error code on a Kenmore washer signifies an issue with the water supply to the washer. This means the washer isn't getting enough water to fill properly during the wash cycle.
Here are the common reasons behind an F20 error
- Closed water faucets - Make sure both the hot and cold water faucets are turned on completely. If your washer only uses cold water, verify that the cold water faucet is open.
- Clogged water hoses - The hoses that supply water to the washer can become clogged with debris over time. Inspect the hoses for kinks or blockages. You can also disconnect them from the washer and faucets to check for clogs inside the hoses themselves.
- Low water pressure - If the water pressure coming into your house is low, it might not be enough to fill the washer properly. This could be due to a temporary issue with the city water supply or a problem within your plumbing.
Here's how you can troubleshoot the F20 error on your Kenmore washer
- Check the water faucets - Ensure both hot and cold faucets are turned on fully.
- Inspect the water hoses - Look for any kinks or visible blockages in the hoses. You can also disconnect them and check for clogs inside the hoses themselves.
- Test the water pressure - Run another faucet in your house, preferably close to the washer, to see if the water flow seems weak. If you suspect low water pressure throughout your house, contact your local water utility company to inquire about the issue.
If you've checked these steps and the error persists, there could be a problem with the water inlet valves or the washer itself. For those situations, consulting a qualified appliance repair technician is recommended for further diagnosis and repair.