H2O SUPPLY, IE, Wash and Rinse
The blinking lights "H2O SUPPLY," "IE," or "Wash" and "Rinse" on your GE washer, combined with the lack of water entering the washer, point towards a problem with the water supply
Explaining the Blinking Lights
- H2O SUPPLY - This light specifically indicates an issue with the water supply to the washer.
- IE - Depending on your GE washer model, "IE" might be an alternative way of displaying a water supply error or a separate code altogether. Consult your user manual to decipher the exact meaning of "IE" for your model.
- Wash and Rinse - Blinking lights for these cycles suggest the washer is programmed to proceed with those stages but cannot due to the lack of water.
Troubleshooting Steps
Here are some steps to troubleshoot the water supply issue:
- Check Water Source: Ensure the shut-off valves on both the hot and cold water lines connected to the washer are fully open. Sometimes, these valves might be accidentally closed or only partially open, restricting water flow.
- Inspect Hoses: Visually examine the water inlet hoses for any kinks, cracks, or blockages. Replace any damaged hoses. Tighten loose connections at the hose ends where they connect to the washer and the water supply valves.
- Clean Water Inlet Screens: Most GE washers have mesh screens at the connection points of the water inlet hoses on the back of the washer. These screens can trap dirt and debris over time, limiting water flow. Locate the screens according to your user manual, remove them carefully, and clean them under running water.
- Check Water Pressure: Low water pressure from your home's main supply can also prevent the washer from filling properly. Open another faucet near the washer and see if the water flow seems weak. If you suspect low water pressure throughout your house, contact your local water utility company.
Additional Tips
- Consult User Manual: Refer to your user manual for specific troubleshooting steps and instructions related to your GE washer model. The manual might provide additional details on the meaning of "IE" and any model-specific procedures for checking the water supply.
- Reset the Washer (Optional): In some cases, a simple reset can resolve temporary glitches. Unplug the washer for 30 seconds, then plug it back in and try running a cycle again.
When to Call a Technician
- No Improvement: If none of the above steps resolve the issue and the washer still doesn't receive water, consult a qualified appliance repair technician. They can diagnose the problem more precisely. This might involve checking the washer's internal water valves, solenoids, or other components related to the water intake system.
- Leaking: If you notice any leaks around the water hoses or the washer itself while troubleshooting, stop using the washer and call a technician immediately. Water leaks can damage your washer and surrounding areas.
Important Note
- Safety First: Always turn off the water supply valves to the washer before disconnecting hoses or attempting any repairs.
By following these steps, you can hopefully identify and address the cause of the water supply problem on your GE washer. If the issue persists or you suspect a more complex problem, consulting a qualified appliance repair technician is recommended.